June 06, 2020, 02:45:27 AM

Author Topic: Tick Remote Clutch Bleeder Install  (Read 275 times)

Offline SEV8N

  • In The Bleach Box
  • Location: Dallas TX
  • Posts: 25
  • View Gallery
    • View Profile
Tick Remote Clutch Bleeder Install
« on: May 22, 2020, 01:36:46 AM »
I just got a Tick remote clutch bleeder for my T56. While the install instructions are straight forward, it came with a 4 ft line. Where would you recommend running this line from the slave clutch?  Every route I look at has it running alongside the headers...   :huh:

This is on a 3rd gen LS1/T56.

Offline largeorangefont

  • Top Fuel
  • Location: So Cal
  • Posts: 6736
  • I steer with the gas pedal.
  • View Gallery
    • View Profile
Re: Tick Remote Clutch Bleeder Install
« Reply #1 on: May 22, 2020, 08:43:15 AM »
Buy a fire sleeve for the line, run it up into the engine bay.

I did a 6 or 8 inch line and just left it under the car and mounted it to a tab on the trans case, fitting pointed down.
Quote from: cool
Sell it to spacevomit.  He'll finish it.

Offline scuter83

Re: Tick Remote Clutch Bleeder Install
« Reply #2 on: May 22, 2020, 09:46:54 AM »
I ran mine along the firewall near the stock brake/fuel line routing ending near the master cylinder.  I didn't originally have a fire sleeve, but as I drove the car each session the clutch catch point seemed to move.  After the insulation it seems more consistent.

Offline SEV8N

  • In The Bleach Box
  • Location: Dallas TX
  • Posts: 25
  • View Gallery
    • View Profile
Re: Tick Remote Clutch Bleeder Install
« Reply #3 on: May 22, 2020, 03:02:01 PM »
Thanks. Iíll pick up a sleeve and some more shielding for the currently exposed fuel lines.