November 17, 2019, 04:28:14 AM

Author Topic: 044 pump surge tank mount  (Read 448 times)

Offline Exidous

044 pump surge tank mount
« on: October 12, 2019, 10:39:12 PM »
I'm going to make a surge tank that fits between the subframe and tank. I want the pump to be mostly submerged but cannot seem to find a seal.

Anyone have ideas?

Worst case I but some cheap crap tank off eBay and make it my own.
94 BB SBE LS1 Full Mamo top, MS3ProU with TC, RONIN 8.8 and another custom dual 2.5" stainless exhaust. Not too loud with the new resonators!

Offline shainiac

Re: 044 pump surge tank mount
« Reply #1 on: October 12, 2019, 11:48:56 PM »
I'm using an Integrated Engineering (IE) surge tank which looks to be what a lot of the eBay sellers have knocked off. It has a beefy 1/2" bulkhead and submerges and seals a single or double 044 pump with an oring. I have mine mounted on it's side and still works well. It also uses ORB fittings so no wories about getting thread tape inside the tank. I believe someone did a write up on rx7club installing an IE surge where you're suggesting.
'88 TII -  SBE 5.3L, Twin EFR 6758s, T56 Magnum, Ronin 8.8" IRS, MS3Pro Ultimate
716whp/662wtq @1.3bar