Drop in molded heater hoses for FD - Part Numbers Included

[Adam P]

Oh I forgot to add the dei foil wrap you need to remove the inner most sewing for it to fit perfectly around the hose 

[dvo]

nice find!

[quinns]

Rather than starting a new post I thought I'd just add some part numbers to this for Dayco brand hoses. Gates products are unavailable to me easily at my location.

Dayco 87611
Dayco 80405

[halfspec]

Rather than starting a new post I thought I'd just add some part numbers to this for Dayco brand hoses. Gates products are unavailable to me easily at my location.

Dayco 87611
Dayco 80405

Thank you for posting. I updated the first post with your information

Lane

[deepfriedbutter]

I read through the whole thread and must have missed it and I can't seem to find the OD sizes for these hoses.

What size of the gates powergrip clamps did you guys buy or what size constant tension?

Thanks!
jaime

[halfspec]

I read through the whole thread and must have missed it and I can't seem to find the OD sizes for these hoses.

What size of the gates powergrip clamps did you guys buy or what size constant tension?

Thanks!
jaime

Sorry. I can't help with either question as I didn't use gates heat shrink bands AND my car is 100 miles away so I can't break out the caliper for OD measurements.

Lane

[spacevomit]

Thanks wompa164

I like constant tension screw clamps but are they any better than worm gear clamps in respect to cutting into hoses?

Lane

Check out these shielded ones by Breeze:
[attachimg=1]

[Cryptic]

Where did you find them? 

[spacevomit]

Found a few as military surplus, just by luck. Military part # MS-35842-12.